Set up and pair Watch RIG with your phone
Follow these general instructions for removing, changing, and fastening bands.
Make sure that you use a band that corresponds to your Watch RIG case size. You can use a band that’s designed for any watch as long as the sizes are compatible.
Remove and change bands
Hold Watch RIG and grab the buckle on the joint between Watch RIG bottom case and the band.
Extract the band from one side of the joint, then install a new band in.
Fasten a band For optimal performance, your Watch RIG should fit closely on your wrist. For best results, the back of your Watch RIG needs skin contact for features like wrist detection, and the heart rate sensor. Wearing your Watch RIG with the right fit—not too tight, not too loose, and with room for your skin to breathe—keeps you comfortable and lets the sensors do their job. Tip: For more information, see "What's in your Watch RIG and bands" and " How to make the result of monitor accurate"